Choice of Black, Blue & Red
8 Glen Watford Dr. Unit 23, Toronto, ON Canada M1S 2C1
Shiny Refill Ink (0.9 oz or 28ml), Water Base,
Self Inking Stamp or Any Rubber Plated Stamps
Choice of Black, Blue & Red
Brother Pro Stamp Refill Ink (20 CC),
for Brother Pro Stamp
How to refill self inking stamp
Self-inking stamps have an internal ink pad that wets the rubber die with ink
after each use. the ink colour usually is black, blue , red, purple or green, even
more for some brands, fromtime to time, the ink pad can run low or dry out,
To refill the ink pad, press the stamp dowm slightly, usually less than a quarter
of an inch, Push the ink pad out from the back of the stamp to the front with your
index finger. Pull it the remainder of the way out of the front. Keep the ink pad
horizontal. Drip five or six drops directly onto the pad. The procedure for
refilling the stamper will vary slightly depending on the individual stamper model,
but the basic process is the same for most stampers. Leave the pad for a few
minutes, press the stamp down slight, same position as you pushed the pad out,
then push the refilled pad back to the position, make sure the same position
before you pushed out the pad. That’s it!
Choice of Black, Blue & Red
Shiny Stamp Ink Pad (For Our RS Series
Rubber Stamp)
Choice of Black, Blue & Red
2-3/4"x4-3/8" (4" Stamp Pad)
3-1/16"x6-1/8" (6" Stamp Pad)
Copyright @ 2010 D & D Graphics Inc. We are specializing in all self inking stamps
COLOP Flash Refill Ink (250 ml),
for Pre-inked EVOStamp
Choice of Black, Blue, Red,
Green & Purple
How to refill EVO Pre-inked stamp
Step 1: Open the cover
Step 2: Drop the ink on
left side hole
Step 3: Drop the ink
onright side hole
(Shiny 28)
(Brother 20)
(Flash 250)
COSCO Flash Refill Ink (10 ml),
for Pre-inked EVOStamp
Choice of Black, Blue, Red,
Green & Purple
(Flash 10)
